Wolfbox Adjustable Camera Mount with Protective Housing

Mount your Wolfbox camera virtually anywhere with a clean, secure, and adjustable mounting solution from OffGrid Nomad Designs.

Designed for versatility and protection, this mount provides a streamlined way to install your Wolfbox camera on compatible aluminum extrusion rails, racks, and other mounting surfaces. Concealed mounting screws maintain a clean, finished appearance without exposed fasteners.

By utilizing part of the original Wolfbox OEM mounting bracket, this design retains the ability to pivot the camera up and down, allowing you to fine-tune your viewing angle while keeping the camera protected within the housing.

Key Features

• Hidden Mounting Screws: Concealed mounting hardware creates a clean, minimalistic installation.
• Adjustable Camera Angle: Reuses part of the OEM Wolfbox bracket to maintain vertical camera adjustment while keeping the camera protected.
• Protective Housing: Surrounds the camera to help protect it from incidental contact and debris.
• Smooth, Sloped Top Surface: Designed to minimize areas where water, dirt, and debris can collect or become trapped.
• Four Wire Routing Options: Route wiring out either side, through the rear slot, or straight down for a clean, organized installation.
• Outdoor-Ready ASA Construction: 3D printed from ASA, a UV-resistant material well suited for outdoor applications and exposure to sunlight, while maintaining superior impart resistance.
• Versatile Mounting: Designed for use on compatible mounting surfaces, including aluminum extrusion rails.
• Low-Profile Design: Keeps your camera installation compact and visually integrated with your setup.
  

Included Hardware

• (1) 1/4"-20 Black coated stainless steel mounting screw
• (1) 1/4" Black coated aluminum channel slide-in nut

Installation Notes

1. This mount utilizes a portion of the original Wolfbox OEM camera bracket to retain vertical angle adjustment. The OEM bracket component and camera are not included.
   
2. pre-stage the 2 OEM pivot screws in bracket tabs through the side slots (snug fit design to retain the screws while aligning the camera.
3. Align camera with OE bracket to pivot screws and attach the 2 assemblies, but DO NOT TIGHTEN pivot screws fully yet.
4. Tilt camera down and install assembly on mounting surface using 1/4-20 hardware.
5. Once camera is wired, adjust angle to your desired aim, and then lightly tighten the pivot screws through the side slots. 

Verify compatibility with your specific Wolfbox camera and mounting setup before installation.

This product is 3D printed and may show very minor surface artifacts, but this has no effect on strength and quality.

This part is designed and 3D printed in North Carolina.

Thank you for supporting our small business!